Frequently Asked Questions about Sculpfun G9, How to Solve Them

1. The machine cannot be turned on

1. Check whether the emergency stop switch is reset
2. Check whether the USB security key is inserted
3. Check whether the connection cable and power cable are connected

2.The function of the Hexagon Wrench

Shaking may occur during transportation, which may cause the focusing mechanism to be offset, resulting in a misalignment of the red and blue dots when focusing. You can adjust the screws with a hexagon wrench to loosen the focusing mechanism, facilitating the adjustment of the focusing mechanism’s position.

3. The machine does not work

a) Check the safety door position and safety door switch. You must use the machine protective cover for normal working when the Safety Door Switch is on in the SGD software.

b) Check the engraving mode selected, please make sure to select the engraving mode correctly.

c) Check whether the software parameters are set to that in the U disk

4. The engraving effect is not good

a）Check whether the engraving objects are level

b)  Check whether the focus is well aligned

c）Check whether the software parameters are set to that in the U disk

How to adjust it when the focusing mechanism is offset

Draw patterns at random for engraving test. It is recommended to use the coherent paper specially for engraving and select the red light source for testing. You can adjust the position of the laser head during the engraving process using the up and down adjustment buttons on the machine. It indicates that the focal length is correct when there are clear patterns on the materials and distinct engraving sound. At this point, you can quit engraving tasks and turn on the focusing function to adjust the position of the red dot, enabling the red and blue dots to coincide.